• The battery tie wrapped in place at the factory. This is to ensure the battery does not become
disconnected during shipment. Cut the tie wrap using wire cutters.
• Remove the battery by gently lifting it straight up from the circuit board. The battery has two
pins that mate with two sockets on the circuit board.
• Replace the battery. A replacement tie wrap is not necessary.
• Cold boot the controller. (Refer to section 11.1.3-Cold Boot in of this manual for the Cold Boot
procedure.)
WARNING: If a cold boot is not done the behavior of the controller is unpredictable.
The controller may now be programmed.
SCADAPack 32 Controller Hardware Manual
May 24, 2006
48
To Next Page
Loading...
