Preparing a VFC400-USB for first use VFC400-USB User Guide 11
Preparing a VFC400-USB for first use
Before your VFC400-USB can record temperature data you need to perform a few setup
steps.
In the Office
These steps are completed in your office, using a PC connected to the internet:
1. Install the batteries into the unit.
2. Download and install the latest version of Control Solutions VTMC 3. You can do
this from the Control Solutions Software Download page.
3. Configure the unit using Control Solutions VTMC software.
On-site
Once you have completed this process, you can take the logger to the location where it
will be installed:
1. Connect external power if you use the VFC400-USB in a stationery application.
2. Connect the probes and place the unit, preferably using a wall mount bracket.
3. Start the logger.
To Next Page
Loading...