Starting the Logger VFC400-USB User Guide 33
l
you keep holding the button for more than 2
seconds after READY disappears; or
l
the AAA batteries are critically low and the
logger is not connected to power.
Push Button Start with Start Delay
If the logger has been configured for a push button
start with a start delay, the word STARTING DELAY
is shown instead of the symbol.
The delay time is shown in hours and minutes. The
time counts down and the VFC400-USB starts
recording when it reaches 0:00.
The timer can be cancelled and the logger reset to
READY.
While STARTING and DELAY are shown, press and
hold the START/CLEAR/STOP button. STOPPED will now
show. Release the button when STARTING
disappears.
STOPPED and DELAY will both disappear, and
READY will show, together with the current time,
and the logger can now be started again as normal.
The VFC400-USB will
not
be reset if you
l
release the button before STARTING
disappears; or
l
keep holding the button until STOPPED
disappears.
To Next Page
Loading...
