Page 27
Motor Thermal Switch
For Motor Thermostat wiring, see the “Control Wiring” section.
Wrong Motor Rotation
If the motor rotates in the wrong direction, one of the following changes will correct it:
Only With Power Removed
Exchange Al and A2 output Motor Armature leads.
or
Exchange Fl and F2 Motor Shunt field leads.
Installation of Option Kits
Do not install option kits until you have verified the basic operation as outlined in the
Start-Up section.
Pre-installation of option kits before verification of basic drive operation will make
troubleshooting much more difficult. Option kits are often installed incorrectly and one
cannot determine if the drive was functional before kits were installed.
When making any wiring or jumper changes, the incoming AC power must be turned of
and locked out. Hazardous voltages will be present until the AC power is turned off. The
drive contactor ( if used ) does not remove hazardous voltages when opened.