X-600M Users Manual Appendix B: Installing New Firmware
Upgrade Procedure
To update the X-600M firmware:
1. Remove the DC power from the X-600M.
2. On your PC, start the X-600M Firmware Update Utility
by double clicking on the update.bat file.
3. With the DC power off, connect the USB cable between
the Mini-B connector on the X-600M and your PC.
4. Press and hold in the firmware update button on the
back of the X-600M. CAUTION: only a gentle force is
necessary. A tactile feedback can be felt as the button
is depressed.
5. While depressing the firmware update button, apply
power to the X-600M. The Firmware Update Utility
should automatically recognize the X-600M and begin
the firmware update. Once the update has started, the
button may be released.
The firmware update process should take between 3 and 5 minutes. When completed, the
Firmware Update Utility will indicate if the process was successful, or if it failed. If it failed, turn
off the X-600M, restart the update utility, press and hold the firmware update button and power-
up the X-600M again. The update process will automatically begin again.
Xytronix Research & Design, Inc. Page 113
To Next Page
Loading...