ControlByWeb X-600M - Appendix I: Specifications

X-600M Users Manual Appendix I: Specifications
Appendix I: Specifications
Power Requirements
Input Voltage: 9-28 VDC (24V power supply recommended)
Input Current: See table below for typical values at 25°C,10/100Mbps.
Expansion bus is powered via the Vin+ terminal
Power
Supply
Input Current
(no expansion modules)
Input Current
(X-600M + 1.7A for expansion modules)
9 VDC 200 mA 1.90 Amps
12 VDC 150 mA 1.85 Amps
24 VDC 80 mA 1.78 Amps
Voltage Outputs
Expansion Bus: 1.70A max
5-VDC (for 1-wire bus): 50mA max
I/O Connector
Type: 5-position, removable, 3.81 mm pitch
Connection wire: Use wire rated for 75ºC (min) for connections to the terminal blocks
Stripping Length: 7mm
Connection capacity: 1.5mm
2
stranded, 1.5mm
2
solid
Conductor minimum: 30AWG (UL/CUL)
Conductor maximum: 14 AWG (UL/CUL)
Conductor Type: Copper
Tightening torque: 0.22 Nm (min), 0.25 Nm (max)
(Replacement part number, Phoenix Contact 1827004)
USB:
Host: USB 2.0 Type A
Device: USB 2.0 Mini-B
Expansion Connector: Provides power and communication for expansion modules.
Connector: Ribbon cable,10-conductor, polarized, 2x5-position, 0.100” pitch
Communications: EIA/TIA-485
Internal Temperature Sensor
Type: digital, 1-wire, (Dallas Semiconductor DS18B20) -40°C to +85°C
External 1-Wire Temperature/Humidity Sensors
Sensors: 32 maximum at short distance. Different combinations of cable length
and sensor types will have different results (e.g., supports 10
temperature sensors and 2 humidity sensors at 550 feet).
Cable Length: 600 ft (180 m) maximum combined cable length
Temperature Sensor: Dallas Semiconductor DS18B20 digital 1-wire thermometer
+/-0.5°C from -10°C to +85°C
Temp & Humidity Sensor: ControlByWeb X-DTHS-WM wall mount sensor
+/-0.5°C from -10°C to +85°C
0-100% RH +/- 1.8%
Xytronix Research & Design, Inc. Page 149