Setup Pages X-600M Users Manual
Privacy Protocol
This is the type of encryption used by SNMP V3.
Privacy Password:
This is the encryption password used by SNMP V3.
4.2.3.6 Network > Advanced Network > Email (Configure Email (smtp) settings)
The X-600M can send Email alerts based on any sensor or input conditions, such as temperature,
time, frequency, digital inputs, power supply levels, and more. It can send text messages to a cell
phone through a wireless carrier's Email bridge. Emails are initiated by an Action (See
Control/Logic > Actions for further details). The message's text that is sent is defined in the Action.
This page is used to configure the Email server used to send outgoing email messages.
Host Name:
The name of the SMTP (Simple Mail Transfer Protocol) mail server (for example mail.example.com)
or the IP address of the mail server (for example 192.10.10.10) should be entered in this field. There
is no default setting for this field.
Note: If the server name is entered and not the IP address, a DNS server must be set up under the
Network menu tab.
Server Port:
This field is used to specify the SMTP Mail Server Port. The default setting is 25, which is the
standard SMTP port.
Return Email:
The X-600M will not receive email messages, but when the X-600M sends email messages, it must
include a return email address. This field is used to specify the return email address. Note that
although the X-600M will send email messages with any email address specified in this field, some
email filters (spam filters) will not allow messages through that include an invalid email address.
There is no default setting for this field.
Page 52 Xytronix Research & Design, Inc.
To Next Page
Loading...