X-600M Users Manual Setup Pages
4.2.3.5 Network > Advanced Network > SNMP (Configure device to communicate with
SNMP manager)
Simple Network Management Protocol (SNMP) is used to manage and administer network devices. The
X-600M supports SNMP V3.0 for SNMP requests and SNMP V2.0 for sending traps. Using SNMP, the
I/O states of devices connected to the X-600M can be read and controlled through SNMP manager
software. See Appendix F: SNMP Requests for information about how to request information from the X-
600M using an SNMP manager.
SNMP Enabled:
When this option is set to Yes, the X-600M will support SNMP. The default setting for this option is
No. (See Appendix F: SNMP Requests, Objects and Security for more information.)
Host Name:
This is the address of the machine where the SNMP manager software is running.
Server Port:
When SNMP is used, this field is used to specify the SNMP port that X-600M listens on. The default
setting for this field is 161.
Trap Port:
When SNMP is used, this field is used to specify the SNMP Trap/Notification port of the SNMP
manager. The default setting for this field is 162.
Username:
This is the username used when setting up SNMP V3 security settings.
Authentication Protocol:
This is the authentication protocol used when establishing a connection with the SNMP manager.
Authentication Password:
The authentication password used when establishing a connection with the SNMP manager.
Xytronix Research & Design, Inc. Page 51
To Next Page
Loading...