X-600M Users Manual Setup Pages
Section 4: Setup Pages
The left side of the configuration and setup pages have click-able tabs which provide access to specific
configuration and setup settings. Each of the tabs are explained the following sections.
4.1 System Tab
The Overview page displays basic information about the X-600M module and its operating system. Note
the Serial Number is the same as the MAC address for the wired Ethernet adapter. The Up Time is the
elapsed time since the last system reset. The Internal Temperature is measured with an internal digital
temperature sensor. Note: The internal temperature is normally higher than the ambient temperature.
External Storage shows the capacity and amount of memory used on the external USB Flash Drive.
Normally the external USB Flash Drive can be unplugged at any time. However, since data logs are
buffered before written to the Flash Drive, when the Flash Drive is unplugged there is risk of loosing the
most recent data log. If this is of concern, click the Eject button to force all buffered data logs to be
written and any open files to be closed before unplugging the USB Flash Drive.
The Dashboard and I/O Password Protection setting can be used to enable or disable password access
for all users. The default setting is Disabled. Check the Enabled setting if you wish to require all users to
enter a password to access the dashboards. If password protection is enabled, Access Groups and
other menus needed to manage password access are displayed in subsequent menus. If password
protection is disabled, Access Groups and other menus needed to manage password access are not
displayed in subsequent menus. Note: If password protection is disabled, access to the X-600M's setup
pages still require an administrator password.
To access other system settings, click System on the menu bar on the left side of the setup screen.
Several subsections will appear.
Xytronix Research & Design, Inc. Page 31
To Next Page
Loading...