X-600M Users Manual Setup Pages
4.2 Network Tab (Current network configuration of a device)
To access the network settings, click Network on the menu bar (left side of the setup screen). The
Overview section displays the general status and settings of the network interface.
4.2.1 Network > Ethernet (Configure Ethernet Settings)
These settings are used to configure the X-600M for operation with a wired network. After entering
settings press Submit and then Commit Changes. When Commit Changes is clicked the new network
settings will take effect immediately. If you have changed the IP address the X-600M will no longer
respond to the current IP address.
Use DHCP:
This option allows DHCP to be enabled or disabled. If this option is set to Yes, the X-600M will wait
Xytronix Research & Design, Inc. Page 43
To Next Page
Loading...