Setup Pages X-600M Users Manual
4.1.1 System > Access Groups (Edit access groups)
This menu and its tab are only displayed if Dashboard Password Protection in the System>Overview page
is set to Enabled. Users, I/O, and dashboards are assigned to one or more Access Groups. Users can only
access I/O and dashboards that belong to the same group that they do. Only users that belong to the admin
Access Group are allowed to configure the X-600M settings. Only I/O that belong to the CBW Access Group
can be controlled remotely by other ControlByWeb devices. All other Access Groups are generic and can be
used for any purpose.
The following example illustrates the use of access groups.
The image above depicts a scenario where 3 access groups are being used. There are 6 users
configured on the X-600M and 7 relays. To determine if a user has access to one or more of the relays
examine the access group. (depicted as a circle). The 3 users in the Admin access group, Mark, John,
and Sara, have access to any relay also found in the Admin group: relay 1, relay 2, relay 3, and relay4.
The 3 users in the User access group, Jennifer, Ryan, and Mike, have access to any relay also found in
the User access group: relay 2, relay 4, relay 5, and relay 6. There are no X-600M users in the CBW
access group. The CBW access group is a special group. All other ControlByWeb products that can
Page 32 Xytronix Research & Design, Inc.
To Next Page
Loading...