ControlByWeb X-600M - Network > Wireless (Configure Wireless Adapter)

X-600M Users Manual Setup Pages
this field is 192.168.1.1. Note: This is the same DNS settings found on the Wireless setup page.
IP Filter Range 1:
This option specifies a range of ip addresses on the subnet that should be allowed access to the X-
600M. By default all ip addresses on the subnet are allowed.
IP Filter Range 2:
This option specifies another range of ip addresses on the subnet that should be allowed access to
the X-600M. By default all ip addresses on the subnet are allowed.
Speed:
This option sets the speed of the Ethernet port - either 10 Mbps or 100 Mbps. The 100 Mbps option
offers faster communications but the amount of data to and from the X-600M is so small that users
will not likely notice much (if any) difference between that and 10 Mbps. The default setting for this
field is 100 Mbps.
Mode:
This option allows the Ethernet port to be set to Half Duplex or Full Duplex. Legacy Ethernet
operates in Half Duplex mode which means that devices can either send data or receive data, but
not both at the same time. Full Duplex means that devices can send and receive data at the same
time. The default setting for this field is Full Duplex.
4.2.2 Network > Wireless (Configure wireless adapter)
These settings are used to configure the X-600M for operation with a wireless network. The X-600M
supports both Ad-Hoc and Access Point connections. For wireless networking, a USB network
adapter is required.
With an Ad-Hoc connection users can access the X-600M directly using a smart phone or other
compatible WiFi-enabled devices. The network does not rely on a pre-existing infrastructure, such
as routers or access points. The devices are free to associate with any other ad-hoc network device
in link range. To configure an Ad-Hoc wireless network, select ▼Ad-Hoc from the drop-down menu
and enter a security key for the network. The security key must be exactly 10 hexadecimal
characters.
For an Access Point connection, the X-600M attempts to connect to a wireless access point. To
configure an Access Point connection, select ▼Access Point from the drop-down menu.
Xytronix Research & Design, Inc. Page 45