Setup Pages X-600M Users Manual
Network Name (SSID):
The SSID (Service Set Identifier) is the name of your access point.
Security Level:
Type of authentication used by the access point for connections.
Security Key:
If a password (i.e. security key) is required to access your wireless access point, enter it here.
Encryption Type:
Select the data encryption type from the drop-down menu. This setting must be identical with the
setting of wireless access point you wish to connect.
Use DHCP:
This option allows DHCP to be enabled or disabled. If this option is set to Yes, X-600M will attempt
to obtain an ip address from the access point each time it is powered. The default setting is No (this
is recommended for most installations). If you set DHCP to Yes, press Submit and then Commit
Changes. When Commit Changes is clicked the X-600 will immediately request a new DHCP
address from the server. Once X-600M is assigned an IP address by the DHCP, the new IP address
can be found through the list of clients kept by the DHCP server. For most instances, the DHCP
server is the local gateway or router.
IP Address:
The IP address must be unique to your wireless network.
Netmask:
The Netmask (subnet mask) defines the size of the local network. This can be obtained from the
network administrator. For additional information about sub-netting and IP networking, many tutorials
are available on the Internet. The default setting for this field is 255.255.255.0.
Gateway:
This specifies the IP address of your network's wireless access point (Router, etc.).
Preferred DNS:
Page 46 Xytronix Research & Design, Inc.
To Next Page
Loading...