X-600M Users Manual Setup Pages
Connection Security:
If the SMTP server supports SSL/TLS encryption, then enable it here. SMTP servers that require
SSL/TLS encryption will not work unless this option is enabled.
User Name (If Required):
If the SMTP mail server requires authentication, the user name must be entered here. There is no
default setting for this field.
Password (If Required):
If the SMTP mail server requires authentication, the password must be entered here. There is no
default setting for this field.
Test Email
Click this button to test your SMTP settings by sending an email to the email address associated
with the admin account.
4.2.3.7 Network > Advanced Network > FTP (Configure FTP settings)
The X-600M can be configured to upload log files to an FTP server. The X-600M functions as an
FTP client (not a server). FTP settings are configured here.
Host Name:
The IP address or host name of the FTP server.
Port:
The TCP port to which the FTP server listens on. The default value is port 21, as most servers will
listen on this port.
User Name and Password:
These are the credentials that are submitted to the server when the connection is established. Both
are case sensitive. For anonymous login, leave the User name at its default value, and leave the
Password field blank.
4.2.3.8 Network > Advanced Network > NetBIOS / mDNS (Setup)
To configure a new X-600M using its built-in web pages, you must either temporarily change the IP
address of the connected computer or use NetBIOS/mDNS to access the X-600M after it has obtained
an IP address using DHCP (see Section 3.1). These settings enable/disable NetBIOS and mDNS, as
well as configure the name to be used when addressing the device using this service. Both services
Xytronix Research & Design, Inc. Page 53
To Next Page
Loading...