X-600M Users Manual Setup Pages
Access Groups:
This determines to which access groups this I/O belongs. Only users that belong to the same
access group will have access to this I/O when Dashboard and I/O Password Protection is enabled.
If the 1-Wire sensor is found on another device, a similar set of options will be presented. For these
sensors an 1-Wire sensor address will not need to be defined, but the units for the remote sensor will.
4.4.2 I/O > Registers (Add, edit, and delete Registers)
Programmable logic devices use memory locations to store data and status values. These user-defined
locations have various names in the automation industry (RAM, Variables, Tags, Registers, etc.). The X-
600M designates these as “Registers”. Registers are created and defined by the user to work as a local
scratch-pad memory to hold data. For example, perhaps you would like a temperature sensors data to
be displayed in both °C and °F, so you would create a register for the °F value and imbed an expression
(script) in it to update the °F register based on the °C value of another register or I/O.
The Registers menu tab presents a list of the current registers. To add a new register, click Add New
Register
Xytronix Research & Design, Inc. Page 63
To Next Page
Loading...