Setup Pages X-600M Users Manual
Device:
This is the device that the I/O resides on. Only registered devices will appear in this list.
Device Relay (Input, Analog Input, Etc.) Number:
This is the I/O number on the device itself. For example, if this I/O represents the third relay on the
WebRelay-Quad, then this number would be 3. If it were to represent the fifth 1-Wire temperature
sensor on an X-300, then this number would be 5.
Name:
Names are short identifiers (20 character max) that are used in Lua scripts to reference I/O. They
may not contain spaces or special characters, and must begin with a lowercase letter.
Description:
The text in this field (60 character max) appears to the left of the I/O component on the Dashboard.
This text also appears in the Email status message when email are sent.
Decimal Places:
This determines the number of digits displayed to the right of the decimal point for this I/O's data in
the Dashboard and in Emails. For example, if the resolution of a temperature sensor is 0.1C°, you
would want to set Decimal Places = 1. This field is only available for analog I/Os.
Power Up Mode:
This setting is only available for devices with relays and for WebSwitch outlets. This setting
determines the initial state of relays when the X-600M first turns on. The options are Off, On, and
Last State. Off, and On are self explanatory, the Last State option allows the relay to be set to the
state it was in before it lost power. This option is available for up to 40 relays.
Page 60 Xytronix Research & Design, Inc.
To Next Page
Loading...