ControlTemp CT2001 - Page 54

CT2001 Touchscreen Programmable Thermostat
Installer Setup
Name
Settings
Notes
Initial
Setting
Record
Daylight Savings
1-daylight savings is on (factory setting).
0-daylight savings is off.
Set to 0 in areas that do
not follow daylight
savings.
Remote
Temperature
Sensor (Outdoor or
Indoor)
0-no remote temperature sensor.
1-outdoor temperature sensor for display only.
2-outdoor temperature sensor for control.
Outdoor sensor used for Heat Pump Lockout
settings. (See Heat Pump Temperature Lockout
section for more details.).
3-indoor temperature sensor.
Defaults and Options
depend on System Type
selection.
Indoor Temperature
Sensor uses an averaging
network and does not
include on-board sensor.
Heat Pump
Compressor
Lockout or (Balance
Point)
0-no compressor lockout.
15°F (-9.5°C)
20°F (-6.5°C)
25°F (-4°C)
30°F (-1°C)
35°F (1.5°C)
40°F (4.5°C)
45°F (7°C)
Default depends on other
selections. Shown if
control is selected. (See
section for more
information.)
Table 3. Installer Setup Menu. (CONTINUED)