Convotherm OEB Series User Manual

Service manual OEB/OES/OGB/OGS
5_00e Troubleshooting list_L 12/27 2013-01-30
E
T
O
E
B
O
E
S
O
G
B
O
G
S
Error-
message
Error description possible cause or remedy

Control defective or faulty cable
 Air inlet valve clogged or blocked






E65
ID81
Cleaning termination
by general error*
 EMV-error CM
 Conducted interference CM during cleaning
* = at the start of the automatic cleaning program (Since software version 1.3.0.20)
**= during the automatic cleaning (Since software version 1.3.0.20)









E81.xxx Program memory
error
 If the working parameter of a multi-step program are not
between min. and max. values.
 After saving a cooking plan in the cookbook the
temperature display is changed from °C to °Fahrenheit.









E82.xxx WP error
(operating parameter
error).
Until incl. V5.0 exist,
then E97.xxx group
error.
 If the working parameter of the cooking program are not
between min. and max. values.
 Invalid data stored in the cookbook









E83.xxx
ID47
Algo error (invalid
cooking algorithm)
 Incompatible software between operating module and
control module.






ID48
No data valid at the
IDM Modul
 IDM module is defective
 Checksum faulty -> take Unit 10 sec. from the power and
restart









E96.xxx
ID30
Connection faulty
between control
module and operating
module
 Moisture on the electronic boards
 Interface cable between control module and operating
module interrupted
 Plug on the control module or operating loose
 Communication between CM and OM disturbed briefly ->
take Unit 10 sec. from the power and restart
 Wrong software on the CM (at ET)
 CM is defect (at ET)






ID30
Connection faulty
between control
module and operating
module
 Cable between ET-OM and CM defect or not properly
contactable -> control.
 CM software not suitable to ET-OM software -> over-
setting service-io update the CM





E97.xxx Group error
 The error appears when a detailed report cannot be
produced.






E99.xxx
ID31
Communication
Interface to the CM
cannot be opened
 Initialization fault of the COM port -> take Unit 10 sec.
from the power and restart






E99.9
ID32
General Initialization
error
 Take Unit 10 sec. from the power and restart

Convotherm OEB Series Specifications

General

Brand	Convotherm
Model	OEB Series
Category	Commercial Food Equipment
Language	English