Mini-world service manual
KD / 31.03.2009 6_01d_Steuerelektronik demontieren und montieren_Mini_b_EN.doc
Page 4 / 8
Unplug the plugs X4, X1 and X9,
X13 and X21 and the potential
equalization on the operating
module.
Undo the 4 x M5 self-locking nuts
from the bearing plate with a SW 5.5
socket spanner. Do not damage the
thread of the fixing pins when doing
so.
Detach the cable leading to the
speaker and to the main switch.
Remove the operating module and
the bearing plate from the fixing pins
by pulling them backwards evenly
and in a straight line. Do not lose
the spacers
Caution: Do not damage the speaker
or the main switch when removing the
bearing plate.
Instructions: Assembling operating module
Insert the bearing plate and the
operating module onto the fixing
pins evenly and in a straight line.
Caution: Avoid creating tensions
and do not damage the thread of the
fixing pins.
Screw on the 4 self-locking nuts with
a SW 5.5 socket spanner and
tighten them.
Insert the X4 plug into the correct
position (observe + and -). Now fit
the plugs X1 and X9 and then X13
and X21 to the operating module
again.
Re-assemble the upper cover on the
appliance (see service instructions
“6.4 Disassembling and assembling
housing parts”).
Check:
If the easy touch welcome screen
appears after switching on the
appliance with the main switch,
the operating module and the
display are working correctly.
New picture with all plugs
To Next Page
Loading...
