Mini-world service manual
KD / 31.03.2009 6_01d_Steuerelektronik demontieren und montieren_Mini_b_EN.doc
Page 5 / 8
N.B:
Options such as (core temperature sensor) are automatically activated after
installation. No calibration or adjustment is necessary (Plug&play).
6.1.3 Replacing control module (CM) ST5010
Information:
Control module item no.: 5019306
The control module is the central control element with the relays, inputs and
outputs (temperature sensor, digital). It undertakes the regulation and control
tasks and switches 220 V.
The control model is the same for all P3 appliances and Mini 6.06 / 6.10 / 10.10.
Check:
If the green LED 43 on the front of the control module is lit or flashing, it is
working correctly (module self test).
LED 43 see 6.1.4 Position of the LEDs on the controllers
Instructions: Disassembling control module
Disassemble the upper cover (see
service instructions “6.4
Disassembling and assembling
housing parts”).
Remove all plugs X10 to X17 (if
present) from the control module.
Caution: Press the stop lugs
when doing so.
Disassemble all 8 screws and
carefully lift the control module from
the fixing pins.
Caution: Do not lose the spacers.
Instructions: Assembling control module
Place the control module in the correct
alignment on the fixing pins.
Caution: Make sure that all spacers
are present and that you fit the
control module without any tensions.
Screw on the 8 screws and tighten
them.
Plug in the plugs X10 to X17
(if present) again.
X11 X10
X12
X13
X14
X15
X16
To Next Page
Loading...
