Convotherm OEB Series User Manual

Service manual OEB/OES/OGB/OGS
3.2 Error messages
i
Information:
 Possible errors or malfunctions which can arise during operation are displayed
by the electronics in the display with an error number EXX.X and with a short
description of the error as well.

These errors can subsequently be read from the error memory r38 in the
service programme. Using the "Mr.C" button the date and time of the error
message can be called up.
 In error mode all actuators are switched off, the buzzer sounds and the
appliance goes into error mode. After confirmation of the error with the
button, the CONVOTHERM can only be operated with the emergency
programmes.
Possible error messages:
Error
no.
Message in the
display
Description OES
6.06
OEB OES OGB OGS
E01.0 Not enough water Not enough water X X X X X
E02.0 Elec. temp. too high Excessive temp. in the wiring space X X X X X
E03.0 Fan malfunction Fan malfunction X X X X
E03.zzz-
xxx-yyy
Fan malfunction Fan malfunction / Frequency converter error X X
E04.0 Elec. fan malfunction Auxiliary fan malfunction X X X X X
E05.0 No gas No gas or error in the burner system X X
E05.1 No gas No gas at the burner HA1 X X
E05.2 No gas No gas at the burner SG X
E05.3 No gas No gas at the burner HA2 X X
E05.4
E05.4-1
E05.4-2
No gas Start speed at the burner HA1 not reached X X
E05.5
E05.5-1
E05.5-2
No gas Start speed at the burner SG not reached X
E05.6
E05.6-1
E05.6-2
No gas Start speed at the burner HA2 not reached X X
E05.7
E05.7-1
E05.7-2
No gas Full load speed at the burner HA1 not reached X X
E05.8
E05.8-1
E05.8-2
No gas Full load speed at the burner SG not reached X
E05.9
E05.9-1
E05.9-2
No gas Full load speed at the burner HA2 not reached X X
AS/11-2011 3_02e Error messages_c
Page 1 / 2

Convotherm OEB Series Specifications

General

Brand	Convotherm
Model	OEB Series
Category	Commercial Food Equipment
Language	English