CoolPlug CooLinkHUB HVAC Bridge Connecting CoolPlug FJ
QIG Version 2.2 12 CoolPlug CooLinkHUB
6.2 FJ (Fujitsu/General) - Option 2*
1
Connecting the CoolPlug to the CooLinkHUB
Connect the signal wires of the PBUS cable coming from the [VDC-], [1] and [2]
terminals on the CooLinkHUB to the corresponding [-], [1] and [2] terminals on the
CoolPlug.
2
Connecting the CoolPlug HVAC Line to the Fujitsu Indoor Unit
Connect the CoolPlug’s [W1], [B1], [R1] terminals to indoor unit. Consult HVAC
manufacturer’s Installation Manual for instructions.
3 Optional: Connect the CoolPlug’s [W2], [B2], [R2] terminals to the Fujitsu Wired Remote
Controller (W.R.C.)
* For indoors that work with EZ-099 or compatible type wired remote controllers.
* Reset power, once the CoolPlug is installed
To Next Page
Loading...