This equipment is to be installed by an accredited electrician or equivalent technical
person, as per
these installation instructions.
Read the installation instructions before connecting
the system to the power source.
All electrical work must be performed by a licensed technician, according to local regulations.
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Installation of the equipment must comply with local
and national electrical legislation for
installation of
electric equipment.
Do not install the devices outdoors or exposed to
direct solar radiation, water, high relative
humidity
or dust.
Install the equipment only in a restricted access
location.
When wall mounting, be sure to fix firmly on a stable
surface and in accordance to the
instructions below.
When DIN rail mounting, fix the devices properly to
the DIN rail following the instructions
below.
When mounting on DIN rail inside a metallic cabinet
be sure to properly connect to earth.
Unplug power when connecting the wires.
Pay attention to the polarity of power and
communication cables when connecting them.
Disconnect power of any bus or communication cable before connecting the system.
Cautions
Failure to follow CAUTION may result in serious injury.
Do not allow children to play with the CoolPlug or CooLinkHUB.
Do not disassemble, modify or repair the CoolPlug or CooLinkHUB, do contact
CoolAutomation for support. Unauthorized modifications or repairs may result in electric
shock or fire.
Do not expose the CoolPlug or CooLinkHUB to moisture. Water can damage the
CoolPlug or CooLinkHUB resulting in an electrical components failure, electric shock or
fire.
To Next Page
Loading...
Need help?
General
