Coolerado M50C - Step 3-Clearance Requirements

Coolerado Installation
Page 7 of 63
3-Ply Panel Filter, Figure 4
DANGER: Do not expose the intake air to flammable liquids
or vapors.
CAUTION: Do not substitute 2” (50 mm) filter with two 1”
(25 mm) filters, this will significantly reduce the airflow
through the unit. See Figure 5
Filter image, Figure 5
Step 3—Clearance Requirements
1.) Inspect clearances and position the unit for
installation – see Appendices 8, 10 or 12 for unit
dimensions and clearance details per model.
2.) Familiarize yourself with the unit’s connection and
service points. See Figure 6.
Exhaust Out Back,
(Removable for Duct
Installation)
High Voltage Power
Factory Wired
Connections
Soap
Pump
Control Wiring,
Low Voltage
Do Not Block
Filter Access Door
Filter Access
Door Handles
Lifting Lugs
Drain
Water In
Low Voltage Wire
Terminals In
High Voltage Wire
Terminals In
Outdoor
Air In
Identifying System Components, M50C, Figure 6
NOTE: Ensure unit is positioned so that filters, soap pump
and electrical service areas are easily accessible for
maintenance and seasonal changes.
NOTE: Figure 7 shows the working exhaust air from the top.
For units using side working air exhaust.
CAUTION: Ensure a minimum of 24” (610 mm) clearance for
side mounted working air exhaust.
NOTE: Take precautions not to block service areas of unit
and that the ductwork connection has enough flexibility for
leveling or seasonal re-leveling purposes.
Panel
Filter
3
-
Ply Panel
Filter