21
CX-CT6C
2.4GHz 6 Channel FHSS Technology
Digital Proportional Radio System
IDLE SW
10.10. PIT.CURV
Pitch curve
Operation:
1. Press “up” to select “FUN.MENU”, and press “ENTER” to come to the interface.
2. Press “up” or “down” to select “PIT.CURV”, and now the shadow area is the item that can be set
currently. Press “ENTER” to go to the next step.
3. There are three pitch curves to be selected, normal, IDLE 0 and IDLE 1 by the switch at the left
top of the transmitter.
4. Press “up” or “down” to select the pitch curve point. There are 5 points, they are L, 1, 2, 3, H. Press
“INC” or “DEC” to set the corresponding value separately, and the pitch curve will change accordingly.
5. After your setting, press “EXIT” to save the setting and leave the operation.
Remark: the transmitter can save 3 groups of different pitch curves.
IDLE SW
OFF
0
1
PIT. CURV
NOR
I
O
L
0
0
0
PIT. CURV
IDLE1
I
O
H
20
20
100
10.11. THRO.HOLD
Throttle hold
Operation:
1. Press ‘up” to select “FUN.MENU”, and press “ENTER” to come to the interface.
2. Press “up” or “down” to select “THRO.HOLD”, and now the shadow area is the item that can be set
currently. Press “ENTER” to go to the next step.
3. Set the “TH.HOLD” switch at the top of the transmitter. When “TH.HOLD” is in “0” position, LCD
shows SW “OFF”; When “TH.HOLD” is in “1” position, LCD shows SW “ON”. Press “INC” or “DEC” to set
the hold position.
4. After your setting, press “EXIT” to save the setting and leave the operation.
ENTER
FUN.MENU
THRO.HOLD
TH.HOLD
To Next Page
Loading...