36
When there is an abnormality in the operation of the robot, the power indicator light flashes red and voice prompts, please refer
to the following table to solve the problem.
5. Troubleshooting
Error Prompts
Error 1: Laser sensor is blocked or stuck,
please check.
The laser sensor is blocked or jammed by dirt. Clean the laser sensor. If the
obstacles cannot be removed, move the FL022 Robot to a new position and
then start it.
Error 2: Collision sensor get stuck,
please check the collision sensor.
The bumper is stuck. Tap the bumper several times to remove the debris.
If there is no debris, move the FL022 Robot to a new position and then start it.
Error 3: Main roller brush is entangled,
please clean it.
The roller brush may be entangled with debris. Please disassemble and clean
the roller brush.
Error 4: Anti-fall sensor is blocked,
please check and clean anti-fall sensor.
The FL022 Robot is suspended. Please move the FL022 Robot to a new
position and then start it. This fault may occur when the cliff sensor is too dirty.
Please wipe the cliff sensor.
Error 5: Side brush is entangled, please
clean the side brush.
The side brushes may be entangled with debris. Please disassemble and
clean the side brushes.
Error 6: Right/Left wheel is entangled,
please clean the right/left wheel.
The wheel may be entangled with debris. Please clean the wheel and start
the FL022 Robot again.
Error 7: The robot is trapped, please
remove the robot.
The FL022 Robot may be stuck. Please remove the obstacles around the main
unit.
Solutions
To Next Page
Loading...
