37
Error Prompts
Error 8: Low battery, please charge... The power is insufficient. Please charge the FL022 Robot before using it.
Error 9: Top cover of laser is blocked
or stuck, please check
The laser pressure sensor is pressed or stuck. Please move the FL022 Robot
to a new position and then restart it.
Solutions
Problems
Failed to power on the machine
Failed to charge the machine
The battery power is insufficient. Please use the FL022 Robot after charging
it on the docking station.
The battery temperature is too high or too low. Please use the FL022 Robot
when the ambient temperature is 0°C to 40°C.
The docking station is not connected to the power supply. Please make sure
that both ends of the docking station power cord are properly connected.
The docking station is not in proper contact with the FL022 Robot. Please
clean the butting charging pole piece on the charging dock and the FL022 Robot.
Check whether the docking station indicator is on.
Solutions
Slow charging
When used in a high or low temperature environment, the FL022 Robot will
automatically decrease the charging speed to extend the battery life.
The charging contact area may be dirty. Please clean the area with a dry cloth.
To Next Page
Loading...
