Coredy FL022 - Wi-Fi Connection

40
Before Wi-Fi setup, make sure Coredy Robot FL022 and
your Wi-Fi network meet the following requirements.
Wi-Fi Network:
Use the correct password for your network.
6. Wi-Fi Connection
Wi-Fi Setup Requirements
-
Do not use a VPN (Virtual Private Network) or Proxy
Server.
-
Your Wi-Fi router supports 802.11b/g/n and IPv4
protocol.
-
You are using a 2.4GHz router or a dual-band router
that is configured to support a 2.4GHz frequency
band.
Coredy Robot FL022 does not support 5GHz
frequency band.
If Coredy Robot FL022 cannot connect to the Wi-Fi
network and you are using a 2.4/5GHz mixed
network, switch to a 2.4GHz network for Wi-Fi setup.
You can switch back once your setup is complete.
When connecting to a hidden network, make sure
you enter the correct network name, SSID (case
sensitive), and connecting to a 2.4GHz wireless
network.
-
When using a network extender/repeater, make
sure the network name (SSID) and password are
the same as your primary network.
The firewall and port settings of your Wi-Fi router
allow Coredy Robot FL022 to connect with the
Coredy servers.
WPA and WPA2 using TKIP, PSK, AES/CCMP
encryption.
-
Coredy Robot FL022:
Coredy Robot FL022 is fully charged.
Wi-Fi status light slowly flashes blue.
-
-
Network Security Requirement
The FCC requires that all wireless devices in the
United States operate on the 1-11 wireless spectrum
channels.
-
Some countries outside North America can use
spectrum channels higher than channel 11. Refer to
your local regulatory agency to determine which
channels are accessible.
-
A future software release will support access to
channels above 11 for users outside North America.
Until then, use channels 1-11.
If you cannot control Coredy Robot FL022 with your
smartphone, please contact the Coredy service center
for help.
-
Wi-Fi Channels