39
Problems
Is it necessary to charge the battery for
16 hours when the FL022 Robot is used
for the first three times?
The lithium battery does not have a memory effect. It can be used instantly
after it is fully charged. There is no need to wait 16 hours.
The mopping module does not output
water or the water output is small.
Check whether there is any water in the water tank. Use the App to set the
water output to the maximum value.
The power is insufficient during cleaning.
After the FL022 Robot returns to the
docking station for charging, it does not
continue cleaning.
Check whether the FL022 Robot activates "Continue cleaning at break point"
mode on App.
Check whether the FL022 Robot is in DND mode. The FL022 Robot will not
continue cleaning in DND mode.
The FL022 Robot will not continue cleaning if the FL022 Robot is manually put
back into the docking station.
The FL022 Robot cannot return to the
docking station after partial cleaning
or after its position is moved.
The FL022 Robot will re-generate a map after partial cleaning or after it is
moved far away.
If the FL022 Robot is far away from the docking station, the FL022 Robot may
fail to return to the docking station by itself. In this case, manually put the
FL022 Robot back to the docking station.
The FL022 Robot misses some areas
when cleaning.
The front bumper or cliff sensor may get dirty. It is recommended that you
wipe the sensors using a soft dry cloth.
Install the mopping cloth and mop stand properly according to the manual.
Solutions
To Next Page
Loading...
