WLBARGO Manual
38 39
<Wireless setting/802.11g/b setting>
ESSID ESSID is a name that makes wireless adapter identify
this Router . The default ESSID is [corega].
Mode • 802.11b/g: auto connect in either 802.11b or 802.11g.
• 802.11g: connect in 802.11g mode.
Channel When there is interruption, other channels can be
selected.
TX Burst Enable/Disable frame burst function. When it is
checked, transmit throughput will be improved. Only
work with corega WLCBGMO or WLUSB2GO.
Hidden AP when it's enabled, ESSID will not be seen in the
network.
WMM Select [Disable/Enable]to manage function of wireless
bandwidth
WDS P to MP(P to MP bridge mode): setup the wireless
connection with another AP/Router.※Needs to enter
the MAC address of that AP, and each connected AP
needs to have the same setted channel.
AP Repeater (Repeater Mode): When signal is hard to
reach the other AP, users can set this product in AP
repeater mode.※Need to enter the MAC address of
the other AP, and set the same ESSID.
To Next Page
Loading...
Need help?
General