<Advanced setting/Routing Table/Routing Table>
All routing logs are displayed in the table.
<Advanced setting/UPnP >
Activating this function can detect the device or software of LAN, supporting
UPnP. For example: online games supporting UPnP or Windows Messenger
(Ver. 4.7 or above), MSN Messenger (Ver. 5.0 or above) and so forth. Set its
status usable. The default value is [Enable].
<Advanced setting/SNMP >
There are two ways of SNMP:Syslog (UDP) and SMTP(TCP)。
(1) Start SNMP：User can select two ways to start SNMP function. If select
[Local], the product will respond from LAN. If select [Remote], the product
will respond from WAN.
(2) Get Community:this box is in response to the setting of "Get" group of
[GetRequest].
(3) Set Community:this box is in response to the setting of "Set" group of
[SetRequest].
(4) WAN assign IP address:Enter the IP access the product from WAN.
To Next Page
Loading...