A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224
Operator’s manual 111
EN
8.5.b WHEEL POSITIONING (only A224)
- Move the mounting/demounting tool head against the rim edge (g.23a).
- Press button to lock the tool head into the working position (g. 23b).
Important: press button to lock both the vertical and horizontal arms simultaneously
while the mounting/demounting tool head goes slightly upwards moving away from the
rim edge (g. 23).
The space between the rim and the tool head will be maintained for as long as the
handle is in the locking position.
The operator can tilt the pole freely (e.g. when demounting wheels of the same size)
without repositioning the tool head.
- Insert and position the bead lifting lever on the mounting tool head (g.24).
When working with alloy rims or rims with delicate paintwork, you are advised to remove
the bead lifting tool before proceeding with the demounting.
Grip the bead lifting tool rmly during use.
CAUTION
24
23a
23b
To Next Page