Corghi A 2030 - Air Pressure

90 A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator’s manual
-Bead breaking force..........................................................................15000 N (pressure 10 bar)
- Operating pressure....................................................................................................8 - 10 bar
- Air consumption (TI version)………………………….180 Nl/min (average) 764 Nl/min (max)
- Air consumption (NON-TI version)………………….155 Nl/min (average) 520 Nl/min (max)
- Weight.....................................................................................................234 Kg (248 kg TI version)
- Noise level when operating....................................................................................< 70 dB (A)
POWER SUPPLY kW
Number of
rpm
Torque Nm
Weight of the
electrical/electronic
components (Kg)
400Volt/3ph/50Hz DV 0.9 - 1.25 6-12 900 11.5
200/230Volt/3ph 50Hz DV 0.9 - 1.5 6-12 1200 11.5
200/230Volt/3ph 60Hz DV 0.9 - 1.5 6-12 1200 11.5
400Volt/3ph 50Hz 0.75 8.5 1200 11.5
200/230Volt/3ph 60Hz 0.75 8.5 1200 11.5
200/230Volt/3ph 50Hz 0.75 8.5 1200 11.5
200/230Volt/1ph 50Hz 0.75 8.5 800 11.5
200/230Volt/1ph 60Hz 0.75 8.5 800 11.5
110-115Volt/1ph 60Hz 0.75 8.5 800 11.5
200/230Volt/1ph 50/60Hz DV MI 0.75 6-15 1200 10.2
110-115Volt/1ph 60Hz DV 0.75 6-15 1200 10.2
AIR MOTOR / 6.5 800 /
12V 0.6 6.5 / /
The noise levels indicated correspond to emission levels and do not necessarily represent
safe operating levels. Although emission levels and exposure levels are connected, this
relation cannot be used as a safe parameter to determine whether or not further precautions
are necessary. The noise level to which the operator is exposed to depends on a number of
factors, such as duration of exposure, characteristics of the workplace, other sources of noise
etc. Permissible noise exposure levels may also vary from country to country. In all cases,
this information will enable machine users to better assess the danger and risks involved.
1.2.e. AIR PRESSURE
The machine is equipped with an internal pressure limiting valve to minimize the risk of
over inating the tyre.
1. Never exceed these pressure limitations:
•Thesupplycircuitpressure(fromthecompressor)is220 psi (16 bar).
•Theoperatingpressure(indicatedontheregulator)is150 psi (10 bar).
• The tyre ination pressure (displayed on the pressure gauge) must never exceed the
pressure indicated by the manufacturer on the sidewall of the tyre itself.
2. Activate the air ination jets only when inserting the bead.