Corghi A 2030 - Page 97

A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator’s manual 97
EN
500
750
1000
7
Install the tyre changer in the chosen work
position, complying with the minimum
clearances shown in g.7.
The support surface must have a load-
bearing capacity of at least 1000 kg/m
2
.
Ambient working conditions
- Relative humidity 30% ÷ 95% without
condensation.
- Temperature 0°C ÷ 50°C.
CAUTION
Whenever the machine is disconnected from the pneumatic line for long periods,
before restoring the pneumatic supply, check the conguration of the pedals as
shown below.
Before proceeding with the electrical and
pneumatic connection and whenever the electrical
and pneumatic power supply is restored, make
sure that the machine is in the conguration
described below:
- pedal A COMPLETELY LOW
(turntable E closed).
- pedal B COMPLETELY LOW
(pole C not tilted).
DANGER
B
A
C