Use and maintenance manual – 10/2016 Rev. 3 Page 24
[P4] - Grams/ounces selection
This button allows you to display and/or change the currently selected weight unit of measurement. The units available are grams
(GRAM) e ounces (OUNCE).
DISPLAY OF CURRENT UNIT
To display the current unit of measurement, briefly press [P4] . The unit selected is displayed for three seconds, after which
the machine returns to display Ser Ser.
CHANGE OF CURRENT UNIT
To change the current unit of measurement, keep [P4] pressed for three seconds. The new unit of measurement will be
displayed, after which the machine returns to display Ser Ser.
The unit of measurement selected is maintained even after turning off the machine.
[P5] - Inches/millimetres selection
This button allows you to display and/or change the wheel’s unit of dimension currently selected. The units available are inches
(INCHES) and millimetres (MILLIM).
DISPLAY OF CURRENT UNIT
To display the current unit of measurement, briefly press [P5] . The unit selected is displayed for three seconds, after which
the machine returns to display Ser Ser.
Press any key to exit the display of the current unit without waiting for three seconds.
CHANGE OF CURRENT UNIT
To change the current unit of measurement, keep [P5] pressed for three seconds. The new unit of measurement will be
displayed, after which the machine returns to display Ser Ser.
The unit of measurement selected is maintained even after turning off the machine.
[P6] - Imbalance display threshold selection
This button allows you to edit the imbalance display threshold. This procedure is intended for technical support personnel, therefore
it is not described in this manual.
[P9] Not used
This button is not currently used in SERVICE mode.
[F+P1] Not used
This button is not currently used in SERVICE mode.
[F+P3] - Exiting SERVICE mode
This button allows the machine to exit SERVICE mode and return to NORMAL mode.
To Next Page
