Cornelius ED175 - LED Backlight Installation

KIT Base Unit ED175 Installation Instructions
Publication Number: 629097525INS - 10 - © 2016, Cornelius Inc.
15. Snap the nozzle vertical support bracket over the cross member (See Figure 17D).
NOTE: Step 15 is for Shots units only.
16. Insert 4 bushing into the LED backlight hinges (See Figure 18A).
17. Install LED backlight assembly into hinges with 2 hinge pins and insert cotter pins (See Figure 18B).
18. Connect LED backlight harness to the extender cable on the right side of the electrical box (See Figure
18C).
IMPORTANT:
!
Make sure harnesses are properly routed.
19. Latch LED backlight in position, as shown in Figure 18D.
Figure 17A.
Figure 17B.
Figure 17C.
Figure 17D.