Cornelius ICE MAKER - Page 52

47 TD 184
Trouble RemedyProbable Cause
9. Unit goes off on
reset (cont’d)
Auger out of
line causing
excessive wear
on the lower
outside surface
where it rubs
against
evaporator shell
liner at the
bottom
Replace auger and
evaporator shell
Broken auger Replace auger
Evaporator
surfaces worn
or gouged,
causing thicker
ice to be made
Inspect and replace
evaporator if
necessary
Auger guide
bushing worn
down
Replace auger
guide bushing
(corkscrew type
augers only)
Loose
gearmotor
mounting plate
Check and tighten
Low water level
in float tank
reservoir
Adjust float arm to
maintain correct
water level
Worn thrust
washer
Replace