corob D800 HD - Page 3

QUICK GUIDE
At the beginning of the working day
Check that the nozzle center is clean. •
(Without humidier system) Check that the sponge is clean and saturated; if it is necessary to saturate, use •
only appropriate liquid (the choice of the liquid depends on the nature of the colorants, and must be done
directly by the manufacturer of the products used).
(With humidier system for water-based colorants) Check that the water in the bottle is not below the mini-•
mum level.
Carry out system Initialization and Purge.•
Things to remember
Never let the machine OFF.•
In the canisters, stirring of each colorant takes place automatically (stirring times can however be •
customized).
Be careful not to ll the canisters with too much colorant. In case of overlling, act as indicated in the user’s •
manual.
The colorant to be poured inside the canisters must be stirred manually. Do not use automatic shakers.•
Close the canisters with their lids right after lling operations.•
Remember to update accordingly the canisters lling levels via the management software.•
(Without humidier system) The sponge must be saturated at least twice a week (the frequency of interven-•
tion is indicative, since it depends on the nature of colorants and the environment conditions).
(With humidier system for water-based colorants) Top up the water bottle as soon as the minimum level is •
reached. Do not exceed the maximum level.
At the end of the working day
Rell the canisters.•
Update the canister lling levels in the management software.•
Shut down the computer. Do not shut off the machine.•
It is recommended to carefully read the user’s manual.
COROB™ AUTOMATIC DISPENSER