corob D800 HD - Refilling the Humidifier System Bottle

34 - ORDINARY MAINTENANCE
COROB™ D800 HD
In all cases, if the sponge is severely damaged, 5.
replace it.
Fit back the sponge support.6.
Connect power supply and switch on the ma-7.
chine (chapter 5.3).
Close the Autocap...8.
I
it closes automatically
during initialization.
II
bringing the ma-
chine to the on-
line condition, by
means of the off-
line button.
7.7 Relling the humidier system bottle
WARNING
When the water in the bottle reaches the minimum level, ll up immediately.
Disconnect power supply (1. chapter 5.8).
Open the machine upper cover where the bottle is located.2.
Unscrew the bottle cap and add water (1 Pint / 0.5 liters maximum), paying attention NOT TO EXCEED THE 3.
MAXIMUM LEVEL.
To reduce the risk of lime encrustations due to hard water, it is recommended to use distilled water.
Replace the cap and rmly tighten.4.
Close the upper cover, connect power supply and switch on the machine (5. chapter 5.3).
2 3
MAX
MAX
MIN
MAX
MIN
5
0
0
m
l
MAXMAX
MIN
MIN
1
P
i
n
t