4-21
Controls and Indicators
Erasing the User Codes
Make sure the system indicator light is OFF.
Enter the Master Embedded Code, press and release the 1/2 key
and the 7/8 key at the same time to erase the system user codes.
The keyless ignition will now act as if there are no codes in memory.
Pressing the START key will unlock the system and pressing the
STOP key will lock it without entering a code. Follow the steps in
“Programming The Primary User Code” in this section.
Nautique Cruise Control
The steering wheel hub cruise control remote has five control
buttons:
(ON/OFF)
SET
CNCL (Cancel)
s/RES (increment UP/Resume)
t(decrement DOWN)
To Next Page
Loading...
