39
USER
MANUAL
* Equipment available depending on version.
We reserve the right to modify the product and the design.
start-up procedure use of the rear differential lock and unlock*
To begin driving with your CORVUS, follow these steps:
1. Step on the brake pedal, without stepping on the accelerator.
2. Put the gear lever in L, H or R.
3. Release the parking brake. Make sure that is completely disconnected.
4. Accelerate gently in the selected gear. When accelerating the vehicle, it is
possible that on occasions it may not move and it may make a small metallic
noise. This is due to the fact that the gear has not been fully engaged; in this
case, stop accelerating and wait for the engine to return to idling speed,
push the shift lever in the direction you want to go and accelerate gently
at the same time, you will notice a "click" on the shift lever which confirms
that the gear has been fully engaged. You can now release the gearshift
lever and start moving.
To minimise component wear, we recommend that you engage the
lock when the vehicle is at a complete standstill.
It must NEVER be used on the road or on asphalt. The lock may only
be used up to 20km/h.
Failure to comply with this instruction can cause severe damage to
the transmission system and the driveline.
To LOCK the rear dierential, perform the following steps:
1. Step on the brake pedal, without stepping on the accelerator.
2. Disconnect the hand brake. Make sure that is completely disconnected.
3. Put the gearshift lever into NEUTRAL (N) - central position.
To UNLOCK the rear dierential, perform the following steps:
1. With the vehicle completely stopped, step on the brake pedal, without
applying the accelerator.
2. Put the gearshift lever into NEUTRAL (N) - central position.
To Next Page
Loading...
