We reserve the right to modify the product and the design.51
USER
MANUAL
1
2
engine oil (oil and filter change)
You should keep the oil at the optimum level and change it periodically, as
indicated in the Service Chart (see page 44/45).
Procedure:
1. Put the vehicle in a horizontal position.
2. Run the engine so that once the oil is warm it can make any sediment rise
up. Then turn it o after a few minutes.
3. Place a container under the engine to collect the used oil and avoid any
spillage.
4. Remove the cap/dipstick level (1) and the two filler caps (2), to make it
easier to drain the oil.
5. Remove the drain cap/screw (3) and wait until all the content has
emptied out.
6. Remove the filter (4) and discard.
7. Put the new filter in place, lubricate the O-ring seal and tighten manually,
without using any tools.
8. Tighten the cap/screw (3) replacing its washer.
9. Fill with new oil.
10. Ensure the tightness of the cap/dipstick level (1) and the filler caps (2),
with their O-ring.
11. Run the engine for a few minutes.
12. Stop the engine and after about 5 minutes, check the oil level again,
according to the indications of the oil level check.
TECHNICAL INFORMATION: Recommended oil: SAE 15W40 - API
CD, CF, CF-4 and CI-4 / ACEA E-5. Capacity: 1.7 L.
Tighten the drain plug/screw to 58 Nm.
Air cleaner cartridge: 02990000052.
Washer 16: 02990000217.
For the transmission and engine to function properly, keep the oil
at the optimum level and change it periodically, as indicated in the
service chart (see page 44/45).
Insucient, degraded or contaminated oil can accelerate the wear
and tear of a vehicle and cause serious engine damage.
Regulations oblige garages to collect and store, without mixing,
hazardous or toxic waste, contaminated waste and inert non-
hazardous waste. Such waste may not be dumped and must rather
be processed by accredited managers.
3
4
To Next Page
Loading...
