coship CDVB 2300C - Page 37

37
Check that the main cable
is plugged into power
Press the standby button.
Check the Signal Level in
the Antenna Setup menu.
Check the cable
connections, LNB and other
ected
between the LNB and the
receiver, and/or adjust the
Connect a signal attenuator
Change to a larger dish.
Change to an LNB with
e UHF channel
fixed in your system and
Problem Possible Causes What to do
There is
interference on
your digital
satellite channel.
The system is connected
using RF leads and the
output channel of the
receiver interferes with an
existing terrestrial
channel or Video signal.
Change the receiver output
channel to a more suitable
channel, or connect the
system using SCART leads.
Battery exhausted. Change the battery. The RCU is not
working. RCU is incorrectly aimed.
Aim the RCU at the unit, or
check that nothing blocks
the front panel.