32
5. Rotate microwave oven up toward upper cabinet.
NOTE: Do not pinch the power supply cord to lift oven by pulling the
power supply cord.
6. Push microwave oven against mounting plate and hold in place.
NOTE: If adjustment is required, rotate microwave oven downward. Using
2 or more people, lift microwave oven off of mounting plate and set aside
on a covered surface. Loosen wall mounting plate screws, adjust wall
mounting plate, and re-tighten screws. Then repeat the steps above.
7. With the microwave oven centered, and with at least one person holding
it in place, insert 2 self-aligning screws through upper cabinet into
microwave oven. Turn screws until there is no gap between upper cabinet
and microwave oven.
CONNECT DUCTWORK – TOP VENTING
2. Extend the duct system down to connect to the exhaust adapter.
Back of Microwave
Blower Plate
Damper
Exhaust
Adapter
1. Slide and adjust the exhaust adapter within the cabinet opening as
needed to connect to the existing duct system.
To Next Page
Loading...
Need help?
General
