35
PREPARE TOP CABINET – REAR VENTING
IMPORTANT: Read the instructions on the Top Cabinet Mounting Template.
1. Determine the type of the cabinet bottom. If it is recessed, cut the edges
of the Top Cabinet Mounting Template to fit in the recessed cabinet
bottom accordingly.
2. Position and tape the Top Cabinet Mounting Template underneath the
top cabinet.
NOTE:
• On some cabinets a small bracket or glue block is used between the
overhang and the underside of the cabinet bottom. Cut the Top
Cabinet Mounting Template to fit around the bracket or glue clock so
that the template will lie flat against the cabinet bottom.
• Adjust the Top Cabinet Mounting Template accordingly if the
microwave oven is being spaced out from the wall due to oversized
cabinet depth.
Recessed
Cabinet
Bottom
/Flat
Smooth
Cabinet
Bottom
To Next Page
Loading...
