38
4. Remove the knockout plates in the back of the unit with snips. (For some
models)
Carefully snip all 4 webs on each knockout panel and remove the metal
knockouts for rear airflow. Check and remove any sharp edges created
from removing the knockout plates.
5. Place the air director back into the opening.
6. Replace blower plate and cover plate with the screw removed earlier,
and make sure the screw is securely tightened to prevent excessive
vibration.
Knockout
Plates
Back of Microwave Oven
Openings Facing Back
Back of Microwave Oven
Blower Plate
Cover Plate
Back of Microwave Oven
To Next Page
Loading...
Need help?
General
