7
DUAL BATTERY CHARGING
Connect the AC power cord to the AC power supply.
Plug the AC power supply into the DC power pigtail cord.
Plug the DC power pigtail cord into the DC IN jacks of both batteries.
Plug the AC power supply into a wall outlet.
The digital display screen will show the charge level of the battery.
You may press the charge level indicator button to illuminate this screen
for a few seconds at a time.
When charging is complete disconnect the AC power supply from the
wall outlet and the battery.
Note: It is normal for the AC power supply and the battery to be slightly
warm to the touch during the charging process. Do not charge the
Freedom
TM
CPAP Battery on any flammable surface.
Charging the Battery
AC POWER SUPPLY
DC POWER PIGTAIL CORD
AC POWER CORD
DC IN JACKS
28
Power Backup Usage - Single Battery
RESMED AIR 10 & S9 SERIES
Plug the AC power supply of the battery into the DC IN jack of the
battery and then plug the AC power supply of the battery into a wall
outlet (see page 6).
Plug the 24V power converter box into the DC OUT jack of the battery.
Insert the appropriate output cord for your device (Air 10 or S9) into
the power converter box.
Plug the 24V power converter with appropriate output cord attached
into the DC input port of the PAP device (see page 14).
*NOTE: The instructions for connecting the 24V power converter box to the
Freedom
TM
CPAP Battery must be followed in exact sequence.
PAP DEVICES CONNECTED VIA 150W SINE WAVE POWER INVERTER
PAP device models including Fisher & Paykel ICON, DeVilbiss IntelliPAP 2 series, 3B
Medical RESmart and Luna, Apex Medical XT, Somnetics Transcend, and HDM Z1 series
devices connect to the Freedom™ battery via the 150W sine wave power inverter.
Plug the AC power supply of the battery into the DC IN jack of the
battery and then plug the AC power supply of the battery into a wall
outlet (see page 6).
Plug the DC input cord included with the Freedom
TM
battery kit into the
DC OUT jack of the battery.
Plug the 150W sine wave power inverter into the DC input cord.
Plug the AC power supply of the PAP device into the 150W sine wave
power inverter and then into the PAP device (see page 16 for example).
To Next Page
Loading...