3
The Freedom
TM
CPAP Battery is intended to provide external battery power
to PAP (positive airway pressure) devices when AC power is unavailable
during travel or power outages.
The Freedom
TM
CPAP Battery can also be used to power or charge most
common portable electronic devices such as cell phones and tablets.
Use of the battery with a device that has higher amperage requirements
than the output of the battery (over 8A) may cause the internal circuitry of
the battery to shut off to protect from thermal runaway.
All PAP device makes and models have different voltage and direct current
capability requirements which determine the type of external battery that
can be used.
The unique universal design of the Freedom
TM
CPAP Battery allows it to
power most common PAP devices; however, some devices will require a
device-specific connection component that is sold separately from the
standard Freedom
TM
CPAP Battery Kit. See page 1 for more information.
Some older obsolete PAP devices and targeted ventilation PAP devices
may not be compatible with or may require more power than the Freedom
TM
CPAP Battery can provide.
Reference the instructions in this manual for your specific PAP device to
determine which connection components are required. Do not attempt
to connect your PAP device to the Freedom
TM
CPAP Battery before
reading these connection instructions.
If connection instructions for your PAP device are not in this manual or you
have any questions about connecting your device, please contact us at
1-877-445-5228 or via email at info@batterypowersolutions.net.
Intended Use
Compatibility
32
DC INPUT CORD CONNECTION
Plug the DC input cord into the DC OUT jack of the battery.
Plug the device’s DC power cord into the DC input cord.
Turn the device on and it should begin functioning.
The digital display screen will show the charge level of the battery.
You may press the charge level indicator button to illuminate this
screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing
the battery to completely shut down.
Powering Other Devices
150W SINE WAVE POWER INVERTER CONNECTION
You can also connect other small electronic devices that do not have a
USB cord or DC power cord by using the 150W sine wave power inverter in
conjunction with the battery.
In this setup you connect the device’s AC power cord to the inverter and
then connect the inverter to the battery via the DC input cord.
DC OUT JACK
DC INPUT CORD
DEVICE DC POWER CORD
To Next Page
Loading...