A5. Adjustable Feet 4
A6. Hex Nuts ½-12 4
A7. Flange Bolts 5/16-18 x ½ 36
A8. Lower Short Braces 2
A9. Upper Short Braces 2
A10. Router Lift Crank Holder 1
A11. Flange Bolts 5/16-18 x ½ 2
A12. 70mm Spanner Wrench 1
A13. Router Lift Crank Handle 1
A14. Phillips HD Screws
10-24 x 3/8 6
A15. Hose Clamps 2
A16. Starting Pin 1
A17. Hex Wrench 3mm 1
A19. Star Knob ¼-20x ½ 1
A20. Strain Relief ½” 1
A21. Soc. Cap Screws
M4-.7 x 16 (Insert Plate) 2
NOTICE
If you cannot find an item on the list,
carefully check around/inside the
machine and packaging materials.
Often, these items get lost in the
packaging materials while unpacking
or they are pre-installed at the
factory.
Clean Up
The unpainted surfaces of your
CXR1000 are coated with a heavy-
duty rust preventative to protect it
during shipment and storage. This
preventative works very well but will
take a little time and effort to clean.
Be patient and do a thorough job.
The time you spend doing this will
give you a better understanding of
the proper care of your CXR1000.
Listed below we have outlined steps
that work well in a variety of
situations. Always follow the
manufacturer’s instructions with any
cleaning product you use and be sure
to work in a well-ventilated area to
minimize exposure to toxic fumes.
Cleaning Aids:
Disposable rags
Cleaner/Degreaser
Safety glasses
Plastic Paint scraper
Basic cleaning steps:
1. Wear safety glasses
2. Coat the rust preventative liberally
with your cleaner and or
degreaser and let it soak for 10-15
minutes
3. Wipe off the surfaces. The rust
preventative should come off
easily at this point. A plastic paint
scraper will help greatly to remove
the heavier coated areas, wipe the
rest off with a clean rag.
To Next Page
Loading...
Need help?
General
