14
WORK-PIECE INSPECTION
CX500 is designed t o sand wood only. Do
not use this machine to sand m etals, glass
or stone etc.
Before sanding, make sure to inspect the
work-piece for nails, staples, small piec es
of stone or metal and any other object.
Sanding the work-piece with this kind of
objects can tear the sanding paper. Alway s
inspect your work-piece carefully before
sanding and wear eye protection.
Some woods with excessi ve finish or glue
load up the sand paper and reduce its
usefulness.
MAINTENANCE
1. It is highly recommended to clean the
machine daily after use.
2. When the machine is not in use, turn the
switch off and remove the switch key.
3. A build-up of dust i n the motor can
cause motor damage. Periodic cleaning
of the motor is not only recommended,
but also mandatory for normal sander
performance.
4. Keep the machine and attachments
clean.
5. Protect the spindle sleeves from nicks.
Clean tapered sleeves and tapered
socket before use.
6. All bearings are perm anently lubricated
and require no further lubrication.
WARNING
Make sure the machine’s power switch is
off and the cord is disconnected from the
power source when installing/removing
any part or servicing the sander.
To Next Page
Loading...
